Server User's Guide

2-4
Front View (with the Front Door Open)
1 3.5-inch floppy disk drive
Insert a 3.5-inch floppy disk to the 3.5-inch floppy disk drive to read data from the disk or write data to the disk.
1-1: Eject button 1-2: Disk slot
1-3: Floppy disk access lamp (lits green when accessing)
2 CD-ROM drive
See "Lamps" described later.
The CD-ROM drive reads data from the inserted CD-ROM.
2-1: Emergency eject hole - 2-2: CD Tray eject button - 2-3: Access lamp lits orange when accessing)
3
3.5-inch disk bay
The 3.5-inch hard disk bay contains additional hard disk slots. Hard disk drives having the thickness of 1 inch can
be inserted into the slots. The number following the bold-faced character indicates the SCSI ID.
4 DISK lamp
5 Processor board
5-1: Processor board ejector
6 Memory board
6-1: Memory board ejector - 6-2: Memory board power lamp - 6-3: Memory board attention lamp
6-4: Memory board redundancy lamp - 6-5: Memory board attention switch
7 Additional memory board slot
The number following the bold-faced character indicates the slot number.
Additional memory board shall be installed in the slot #2, #3, and then #4 in this order.
8 5.25-inch device bay
DAT (digital audio tape) drive or optical disk drive may be installed in the 5.25-inch device bays. Slot #1 (right)
and slot #2 (left).
9 Additional 3.5-inch disk bay
Install the optional HotSwap HDD cage 3-drive SCSI Media Bay in this bay. With the cage, up to thirteen hard
disk drives can be connected to the server.
2-1
2-2
2-3
1-2
1-3
1-1
4
1
2 3
5
8
7-3
7-4
4
3-0
4
7-2
6-5
3-1
3-2
3-3 3-4 5-1
6
6-1
6-2
6-3
6-4