Electronics America Server User's Guide

I/O Board Installation 5-13

1. Check that the front stabilizer is in the pulled-out position. If not, remove the

screw securing the stabilizer and pull it out (see Figure 5-10).

2. Remove the front bezel from the front of the PCIX unit by pulling it first

from the bottom and then away from the top of the unit (see Figure 5-10).

A Stabilizer

B PCIX Unit Front Bezel

Figure 5-10. Stabilizer and PCIX Unit Front Bezel

3. Remove the two screws (one on each side) securing the PCIX unit to the

front of the cabinet (see Figure 5-11).

A Server Screws (2)

Figure 5-11. PCIX Unit Screws