Electronics America Server User's Guide

3-58 Service Processor
UP (Bring Up System)
Execution:
This command can be executed on a partition in the DC POWER OFF state.
Function:
Turns on the power (DC) of the system, initializes the hardware, and then starts up the
BIOS.
Whether the operating system starts up depends on the BIOS/EFI settings.
Note: The UP command can be executed in Normal mode or
Maintenance mode.
Table 3-47. UP Display Screen
Screen Image Reference
iSPyz:---> upENTER>
This command will bring up the specified partition.
Enter partition number (0-3/all/CR=exit) : all<ENTER>
A
Execute OK? (y/[n]) y<ENTER>
B
UP command was accepted. All partitions will run soon.
C
[iSPyz:INFO.ccc] partition 0 : power on sequence started.
[iSPyz:INFO.ccc] partition 1 : power on sequence started.
:
[iSPyz:INFO.ccc] partition 1 : power on sequence completed normally.
:
[iSPys:INFO.ccc] partition 1 : handed off the control to BIOS.
D
Table 3-48. RS Display Screen References
Reference Description
A Enter a partition number
If you select “all”, all the configured partitions become the targets.
B Displays the confirmation message.
To execute, enter “y.”
C Displays the UP command acceptance message.
The actual process runs in the background.
D Displays the state of the process running in the background.