Datasheet

Installation Instructions MTAPU
7
Figure 6
3. If necessary, the tilt upright bracket knobs may be switched
to allow the brackets to be reversed. (See Figure 7)
a. Remove display from mount.
b. Remove brackets from display.
c. Hold the right upright bracket horizontally, tightly gripping
it so that spacers do not move.
d. Remove the knob, washer and screw.
e. Replace the knob, washer and screw in the opposite
order, with the knob on the inside of the bracket.
f. Switch the right upright bracket to the left side of the wall
mount.
g. Repeat Steps 3c through 3f with the left upright bracket.
Figure 7
Attaching Display to Wall Mount
1. Push upright brackets tabs all the way down so that the
lower mounting slot is blocked. (See Figure 8)
2. Hang the top hook of upright brackets onto the top bar of the
mount. The bottom of the display will be away from the wall.
3. Route cables between wall and bars.
CAUTION: PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
1
2
Knobs
3d
3e
Knobs to outside
of brackets