User's Manual

E-21
capable network to comply with the FCC’s ALI requirements.
The network compliance with the above FCC requirements is dependent
on: (a) the use of digital technology by the wireless network; (b) GPS
satellite signals being able to reach the handset (such transmissions do
not always work indoors, for example); and (c) handset signals reaching
wireless “base stations” (atmospheric and environmental conditions may
cause variations in handset receiving signal strength).
Also the transmission of the ALI information is subject, in part, to system
constraints within the wireless network to which the E911 signal is
transmitted and over which PCD has no control.
Finally, customers are advised that This phone’s ALI capability is to be
used for E911 purposes only.
911 in Lock Mode
The “911” call service is available even in the lock mode.
1. Enter “911” then press the Send Key.
2. The call connects.
3. The phone exits the Lock Mode for 5 minutes.
4. To exit emergency mode, press the End/Power Key.
911 Using Any Available System
1. Enter “911” then press the Send Key.
2. The call connects.
3. The phone remains in Emergency Mode for 5 minutes.
4. To exit emergency mode, press the End/Power Key .