User's Manual

25
Voice/Videophone Calls
To enlarge an image to be sent
Enlarge your image and send it to the other party
during a videophone call.
z The zoom can be adjusted between 2 steps, 1×
and approximately 2×. If you end the videophone
call, the zoom ratio returns to 1× (standard).
z The substitute image being sent cannot be
enlarged.
1
During a videophone callXUse v
to adjust the ratio
Decorating the videophone call screen
<Decoration>
Decorate your videophone call screen (your camera
image) with a stamp and frame.
1
Videophone in-call screen (p.2)X
u (FUNC)X“Decoration”X
Select any item:
Frame……Select a frame from the Frame selection
screen.
Stamp……Select a stamp from the Stamp selection
screen and decide the paste position.
■To erase a frame or stamp
Select “Off decoration” from the function menu of the
videophone in-call screen.
Sending a message during a
videophone call (sending camera
image)
<Petit message>
1
Videophone in-call screen (p.2)X
u (FUNC)X“Petit message”X
Enter a message
The message is displayed. The message
disappears automatically in approximately
15 seconds.
■ To cancel entering a message in text entry
XErase the messageXt
■ To erase the message manually after it is
displayed
Xt (1 second or longer)
You can also erase a message by selecting “Off
decoration” from the function menu.
<Auto redial as voice>
z When a videophone call is switched and redialed
as a voice call, not digital communications
charges but voice call charges apply.
z When a call is redialed, only the voice call is
logged in “Redial”/“Dialed calls”.
z Even if “Auto redial as voice” is set to “ON”, dialing
may not be possible depending on the network or
other party, e.g. the line is busy.
<Hands-free switch>
z Even when “Hands-free switch” is set to “ON”,
handsfree does not activate automatically in the
following cases:
• While Manner mode is set
• When a flat-plug earphone/microphone with
switch (optional) is connected (the microphone
operation is in accordance with “Headset mic.
setting”)
• When holding a call or Record message is
activated for an incoming call
<V-phone while packet>
z Even when “V-phone priority” is set, you cannot
answer a videophone call if you are using multi
access such as i-mode communication during a
voice call.
z When set to “Packet downld priority”, “V-phone
answerphone” or “Call forwarding”, received
videophone calls are recorded as “Missed calls” in
“Received calls”.
z Even when set to “V-phone priority” or “Packet
downld priority”, the “Voice Mail” or “Call
Forwarding” service is activated if the ring time for
the “Voice Mail” or “Call Forwarding” service is set
to 0 second.
N
N
z If “Front camera Reverse” is set to “OFF” for your
camera image, the decoration is displayed
normally, and a stamp with text can be read
correctly.
N
z If “Front camera Reverse” is set to “OFF” for your
camera image, the decoration is displayed
normally, and text can be read correctly.