User's Manual

2
Voice/Videophone Calls
Making a Voice/Videophone
Call
1
Enter the phone number of the
other party
Always start with the area
code, even for a call within
the same area.
You can enter up to 80 digits
for the phone number.
However, only the last 26
digits are displayed.
<When you enter a wrong number>
■ To insert a number
Press v to move the cursor to the number to
the left of the position where you want to insert
the number, then enter the number.
■ To delete a number
Press v to move the cursor to the number you
want to delete, then press t.
Press t for 1 second or longer to delete all
the numbers to the left of the cursor and the
number at the cursor position.
■ To re-enter the number
Move the cursor to the beginning or end of the
number and press t for 1 second or longer to
return to the standby screen.
2
r (voice call), o (V.phone)
<Videophone>
■ To make a videophone call with Chara-
den
XUu (FUNC)X“Select image”X
“Chara-den”XSelect Chara-den
Enter phone number
Function menu ¨ p.4
<Voice call>
“ ” flashes while dialing
and lights up during the
call.
■ If you hear the busy
tone
The line is busy. Call again
after a while.
■ If you hear a message
that the other party
cannot be reached
The other party’s mobile
phone is not turned on or is out of signal
range. Call again after a while.
■ If you hear a message requesting your
caller ID
Call again with Caller ID Notification enabled.
→p.12
<Videophone>
“ ” flashes while dialing
a videophone call and
lights up during the call.
■ If a videophone call is
not connected→ p.5
■ To switch between
camera image and
substitute image
XUu (FUNC)X
“Substitute image”⇔ “My
side”
■ To switch the main screen
XXd (Change)
“Change main disp.” →p.4
■ To enlarge a camera image to be sent
XUse Xv to adjust zoom
■ To mute the voice to send
XYa (マナー ) (1 second or longer)
“ ” appears.
To cancel muting, press Ya (マナー ) for 1
second or longer again.
In-call
Function menu ¨ p.4
Videophone in-call
Function menu ¨ p.4