User's Manual

11
Voice/Videophone Calls
Making a call with a message
You can add Chaku-moji when making a voice or
videophone call from the “Enter phone number”
screen and the detail screen of the “Phonebook”,
“Redial”, “Dialed calls” or “Received calls”.
<Example: To make a call with Chaku-moji from the
enter phone number screen>
1
Enter phone number screen (p.2)
Xu (FUNC)X“Chaku-moji”X
Select any item:
Create message……Enter Chaku-moji. Up to 10
characters can be entered.
Select message……Select a stored Chaku-moji.
You can edit Chaku-moji by pressing o (Edit) on
the message selection screen.
Sent messages……Select a previously sent
Chaku-moji. You can edit Chaku-moji by pressing
o (Edit) on the sent message screen.
■ To delete the entered Chaku-moji (to make
a call without Chaku-moji)
Xu (FUNC)X“Chaku-moji”X“Create
message”XClear the entered text
2
r (voice call), o (V.phone)
●
When you receive a voice or
videophone call with a message
The Chaku-moji appears on the ringing screen. The
Chaku-moji disappears when you answer the call.
z The received Chaku-
moji is displayed in 3D
animation.
N
z Charges apply to send Chaku-moji. Charges do
not apply to receive Chaku-moji.
z You can store up to 30 Chaku-moji in Sent
messages (when 2in1 is active, up to 30 sent
messages in each mode, and in Dual mode, up to
30 in each mode and a total of up to 60 sent
messages are stored). When you send the same
Chaku-moji repeatedly, only the latest one is
recorded. When the number of entries exceeds
the maximum, older entries are overwritten.
When the other party’s terminal receives Chaku-
moji, “Transmission completed” appears.
z If the receiver’s terminal is under the following
conditions, Chaku-moji cannot be sent. In this
case, no sending charges apply.
• The terminal does not support Chaku-moji
(“Transmission failed” appears)
• Chaku-moji does not appear on the receiver
display due to the “MSG display settings” on the
receiver terminal (“Transmission failed” appears)
• Public mode (Driving mode) is set
• The ringing time for Record message is set to 0
second
• “ ” is displayed or the power is off
z Depending on the signal quality, the transmission
result may not appear on the sender terminal even
when the receiver terminal receives Chaku-moji.
In this case, sending charges apply.
z You cannot send or receive Chaku-moji overseas.
N
z Even when you receive a call whose ring tone
sounded for a shorter time than the time set in
“Set mute seconds” under “Ring time (sec.)”,
Chaku-moji is displayed and recorded in Received
calls.
z Some pictograms are not displayed in 3D
animation.
z Depending on the status of the sender or receiver,
Chaku-moji may not be displayed even when you
receive a call with Chaku-moji.
z When the Original lock is set on “Chaku-moji”,
Chaku-moji is not displayed even if you receive a
call with Chaku-moji. You can view the Chaku-moji
in Received calls after releasing the lock.
N
Ex. Voice call
Chaku-
moji