User's Manual

Dra
Dra
Draft, not for public use Output date: 2015-12-14
Draft, not for public use Output date: 2015-12-14
2 3SMILE User manual NE41 14002-02 v1.0 SMILE User manual NE41 14002-02 v1.0
Intended use 3
General funcons 3
SMILE Parts 4
Handling and operaon 4
Mounng 4
Mounng/unmounng the PIN/necklace 4
Mounng the wristband 4
Mounng the CLIP 5
Mounng the HAPA 5
Important 5
Safety Notes 5
Use 5
Cleaning 6
Disposal 6
Technical Data
Intended use
SMILE is intended for use in homes
and wardens to provide a feeling
of security with the possibility to
dispatch alarms in the event of an
accident.
General funcons
SMILE is a portable trigger which must
be connected to a receiver (e.g. NEO
Homecare Phone, TREX2G Portable
Transceiver, D-TECT and D-SERVER
System) to be able to send alarms.
The alarm is trigged by a light touch
on the red alarm buon and the
alarm is acknowledged by blinking
green.
EU Notes
NEAT Electronics declares that this mobile device, type SMILE, is in compli-
ance with the essenal requirements and other relevant provisions:
Direcve:
1999/5/CE (RTTE), 2004/108/EC (EMC), 2006/95/EC (LVD)
Standards:
EMC:
EN 301 489-1 V1.8.1 (2008)
EN 301 489-3 V1.4.1 (2002)
Radio:
EN 300 220-2 V2.3.1 Category III
Low Voltage:
EN 60950-1:2006+A11:2010
US Notes
FCC ID: 2AGLF1400304
Changes or modicaons not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operaon is subject to
the following two condions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operaon.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protecon against harmful interference
in a residenal installaon. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a
parcular installaon. If this equipment does cause harmful interference to
radio or television recepon, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Ulrik Lundberg
Managing director
Informaon in this User manual is subject to change without noce.
NEAT Electronics AB reserves the right to change or improve their products
and to make changes to the content without obligaon to nofy any person
or organizaon of such changes or improvements.
NEAT Electronics AB is not responsible for any loss of data, income or any
consequenal damage whatsoever caused.
For more informaon, details and descripons, visit our web site:
www. neat-group.com/se/en
© NEAT Electronics AB 2015
All rights reserved.
Document number: NE41 14002-02 v1.0
Revision date: 2015-12-14
NEAT Electronics AB
Varuvägen 2
SE-24642 Löddeköpinge
Sweden
Phone: +46 (0)46 707065
Fax: +46 (0)46 707087
www.neat-group.com/se/en
infosweden@neat-group.com
Contents