User's Manual

9WALL Family User manual NE41 12005- 02 v2.0
In the event of inacvity during man-
ual conguraon (e.g. a transmier
is not acvated aer #8 or a port/
buon is not pressed aer #11) the
unit waits for 60 seconds and then
returns to normal mode. The manual
conguraton must then be restarted.
Remove a transmier
To remove a transmier, follow steps
#1 trough #7 above. Aer step #7,
remove jumper J2. The device will
conrm the deleon by rapidly blink
green for 2 seconds.
WALL family Programmer
All WALL units can be congured
with a Neat Programming Unit
(NPU) and the soware WALL Family
Programmer.
The NPU can be purchased from
NEAT Electronics and the soware
can be downloaded from our home-
page: www.neat-group.com/se/en
More informaon
For more informaon, please refer to
WALL Family - Technical Handbook,
NE41 11014-02.
Important!
Care and maintenance
• Do not expose to direct sunlight.
• Keepawayfromdust,moistanddirt.
• Donotdrop,knock,twistorshakethe
device.
• Donotwarmupthedeviceoruseit
nearre.
• Cleanthedevicewithasocloth,damp-
enedslightlywithmildsoapywater.Do
notcleanthedevicewithharshchemicals,
solventsorothercorrosivesubstances.
Safety Notes
• Readinstruconspriortouse.
• Alwaystestthesystemperinstrucons
prior to use.
• Thisproductmaynotbesuitableforall
persons.