User's Manual

6 WALL Family User manual NE41 12005- 02 v2.0
The builn aconplan acvates the
outputs as below.
Mode OUT1 OUT2
Standby - -
Alarm Acve -
Presence - Acve
Assistance Acve Acve
All other products
The relay outputs acts according to
sengs made by manual congura-
on or by a superior system (by
radio).
Jumpers J1 and J2
As default the jumpers J1 and J2 has
the funcons as described below.
Mounted Not mounted
J1 Receiver on, 24V
mode
1
Receiver o,
baery mode
J2 Inputs (IN1 and
IN2) normally
closed
2
Inputs (IN 1 and
IN2) normally
open
2
1
If Jumper J1 is mounted the unit must be
externally powered.
2
IN1 for ROOM and ROOM+PEAR is always
normally open.
However, jumper J2 can be overrided
by using WALL family Programmer
(except for ROOM and ROOM+PEAR).
Buons and LEDs
The buons are used to trig alarms.
For ROOM and ROOM+PEAR it will
also change the unit’s mode.
The dierent modes are:
• Standby mode
• Alarm mode
• Presence mode
• Assistance mode
The LEDs indicate acon and/or the
unit’s state and can either blink or
light steady depending on how the
units is congured and/or used.
Ports 1 and 2
The tele jack connector provides
two ports when a stereo tele plug is
used or one port if a mono teleplug
is used .
The ports are of type
Normally Open.