User's Manual
2 WALL Family User manual NE41 12005- 02 v2.0
Informaon in this User manual is subject to change without
noce.
NEAT Electronics AB reserves the right to change or improve
their products and to make changes to the content without
obligaon to nofy any person or organizaon of such changes
or improvements.
NEAT Electronics AB is not responsible for any loss of data,
income or any consequenal damage whatsoever caused.
For more informaon, details and descripons, visit our
web site:
www. neat-group.com
© NEAT Electronics AB 2015
All rights reserved.
Document number: NE41 12005-02 v2.0
Revision date: 2016-03-03
NEAT Electronics AB
Varuvägen 2
SE-24642 Löddeköpinge
Sweden
Phone: +46 (0)46 707065
Fax: +46 (0)46 707087
EU Notes
NEAT Electronics declares that this mobile device, type
WALL Family, is in compliance with the essenal requirements
and other relevant provisions:
Direcve:
1999/5/CE (RTTE), 2004/108/EC (EMC), 2006/95/EC (LVD)
Standards:
EMC:
EN 301 489-1 V1.8.1 (2008)
EN 301 489-3 V1.4.1 (2002)
Radio:
EN 300 220-2 V2.3.1 Category III
Low Voltage:
EN 60950-1:2006+A11:2010
US Notes
FCC ID: 2AGLF1123001
Changes or modicaons not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operaon is
subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operaon.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protecon against harmful interference in a residenal
installaon. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instrucons, may cause harmful
interference to radio communicaons. However, there is no
guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference
to radio or television recepon, which can be determined by
turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increasetheseparaonbetweentheequipment
and receiver.
• Connecttheequipmentintoanoutletonacircuit
dierentfromthattowhichthereceiveris
connected.
• Consult the dealer or an experienced radio/TV technician
forhelp.
Ulrik Lundberg
Managing director