User's Manual

5D-TECT User manual NE41 08002-02 v2.2
Connecon
The serial bus cable is connected as
shown in the image below.
8
1
# Connecon
①
RS-485 bus, wire A (-)
②
RS-485 bus, wire B (+)
③
Not connected
④
24 V
DC
⑤
Common ground
⑥
Not connected
⑦
24 V
DC
⑧
Common ground
Important
Safety Notes
• Read instrucons prior to use
• Always test the system per instrucons prior to
use and always check the funcon of the product
aer making adjustmentsThis product may not be
suitable for all persons.
• This product should not be a substute for the
roune visual monitoring
protocol by caregiver and must not be used in
situaons where a delay in the arrival of ap-
propriate medical care, could lead to a potenally
life-threatening situaon.
• Our units are NOT intended for any life support
device, thus intending a device whose malfunc-
on may result in damage to a life.
• Check the device regularly and replace when
necessary.
• Do not integrate to other systems other than
those specied in this document.
• The product will not cause electromagnec
disturbances under normal working
condions.
• The product can be placed near other products
or devices as long as mechanical vibraon is not
present.
• Remove baeries if the unit is to be out of use or
stored for an extended period of me.