Daim Ntawv Qhia Tus Neeg Siv

Selecting an NDI source to decode
Once your BirdDog device has entered NDI decode mode
and successfully rebooted, you are able to select the source
that you wish to decode via the web interface.
All available sources are listed in the drop down menu in the
CONFIG. section of the web interface, select the desired
source and press APPLY to begin receiving this source.
Once your BirdDog unit is in Decode mode you can switch
between any available sources on the network by choosing
them from the drop down menu and pressing APPLY again.
Note. BirdDog can only decode video format and frame rate
sources, these formats are the same as what BirdDog
capable of encoding. If you are unable to successfully
receive a source, please double check that the video format
and frame rate are ones that are supported by your unit.
Changing back to NDI Encode operation
To change modes from NDI Decode mode back into NDI
Encode navigate to the CONFIG. section of the web interface.
Select ENCODE mode from the selection box and press
REBOOT DEVICE before APPLY.
Note. You must reboot the BirdDog unit once a new opera-
ting mode is selected, dynamically switching will be added in
an upcoming firmware release.
CURRENT OPERATION MODE
(Change requires reboot)
Current Source
Available Sources
APPLY
DECODE ENCODE
REBOOT DEVICE
DESKTOP-EVS0MMN
DESKTOP-EVS0MM
DASHBOARD NETWORK VIDEO CONFIG. SYSTEM LOGOUT
MINI
CURRENT OPERATION MODE
(Change requires reboot)
Current Source
Available Sources
APPLY
DECODE ENCODE
REBOOT DEVICE
DESKTOP-EVS0MMN
DESKTOP-EVS0MM
DASHBOARD NETWORK VIDEO CONFIG. SYSTEM LOGOUT
MINI
LAPTOP-G5JU04LB (Intel (R) UHD Graphics 620 1)
DESKTOP-EVS0MM
9