User's Manual

98
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
En
4. Make sure the NCredible Flow True Wireless Earbuds are
within 2-3 feet/.6-.9 meters of the device you will be
connecting to.
5. Turn on your device’s Bluetooth. Most devices will
automatically detect your earbuds. Locate and select
“NCredible Flow”. It will indicate that your earbuds are
now connected or paired.
• If your device does not automatically detect your
earbuds, make sure Bluetooth is turned on, do a
SEARCH for “NCredible Flow” and then click
CONNECT.
Notes:
To shut down, press the MFB for 4 seconds or place back into the
charging case. Once paired, the range is approximately 32 feet/10
meters. Your NCredible Flow True Wireless Earbuds will automatically
connect to the last paired and connected device when it is turned
on again.