User manual
Table Of Contents
- Contents
- Preface
- Installation Overview
- Confirming the CMOS Settings and Configuring PCI Adapters
- Confirming the SCSI Adapter Settings
- Installing Microsoft Windows NT Server 3.51
- Installing Microsoft Windows NT Server 4.0
- Installing Windows NT Server 4.0 Enterprise Edition
- Installing Netware
- Installing SCO UNIX
- Installing UnixWare
- Installing OS/2
- Installing MP-RAS
Configuration Settings Required for Installing MP-RAS
11-16 Installing MP-RAS
Embedded Adaptec AIC-7880 SCSI Controller
• On Board SCSI AIC-7880 – Enabled
• Boot device – Enabled
• Configure the on board SCSI to IRQ 11
Disk Array Adapter Mylex RAID Controller
• Disable the on board SCSI boot device in BIOS Setup. This is the “Boot
Device” found under “On Board SCSI AIC-7880” in the BIOS Setup.
• Do not disable the “On Board SCSI AIC-7880” if the intended boot drive
is not connected to the RAID controller.
• Configure IRQ 14 (INTA 14) to RAID controller.