User Manual Chapter 3

3-24 Chapter 3: Installing the Hardware Infrastructure
Installing CBS Antennas
The transmit antenna and receive antenna kits include the same
mounting hardware. The installation procedures for the transmit and
receive antennas are the same.
Mounting an Antenna on a T-bar
Note: Maintain a minimum distance of 9.2 m (30 ft.) between a
CBS's transmit and receive antennas.
To install an antenna on a dropped ceiling's T-bar:
1. At the desired location, install a T-bar hanger on the T-bar.
2. Screw the antenna onto the T-bar hanger.
3. Route the antenna cable through a 13 mm (1/2 in.) hole in the
ceiling tile or route it between the T-bar and the edge of the ceiling
tile.
Note: Do not allow debris from the ceiling tile to fall into the antenna
connector.
4. Install the cable onto the antenna connector.
5. Connect the other end of the antenna cable to the CBS.
6. Use cable ties to secure the antenna cable.