User Manual Chapter 3

3-22 Chapter 3: Installing the Hardware Infrastructure
2. Splice the power cable wires to the pigtail supplied with the power
supply (black to black and red to white) and then install the
provided crimp connectors over the splices.
18878
5
Red
White
Black
Black
2
1
3
White
Black
Note: Colors shown are for recommended Belden
cables. Your wire colors may be different.
7
8
4
6
3. Plug the connector into the power supply.
4. On the CBS, unplug the power connector.
5. Install the power cable wires into the connector (white into pin 1, 3,
5 or 7 [24 V] and black into pin 2, 4, 6 or 8 [Ground]). Use pins in
pairs: 1-2, 3-4, 5-6, 7-8 for each power cable connection at the CBS.
6. Plug the connector back into the CBS.
7. Insert the AC power cable into the power supply's AC receptacle.
8. Connect the AC plug to the AC power source.
Caution: To prevent damage to the transmitter, the transmit antenna
must be connected to the CBS before applying power to the CBS.