User Manual Chapter 3

3-20 Chapter 3: Installing the Hardware Infrastructure
Connecting Secondary CBSs
Follow these steps to connect the secondary CBSs:
1. Cut a length of data cable that is long enough to reach from one
CBS to the next CBS.
2. On each end of the data cable, install the wires into an RJ45
connector as shown in the previous illustration and then crimp the
connector onto the cable.
3. Plug the RJ45 connector into data connector 1, 2 or 3 and into the
Uplink data connector of the next CBS.
4. Repeat steps 1 – 3 until all secondary CBSs are linked by a data
cable.