Tus neeg siv phau ntawv

- 86 -
Change network settings in the oscilloscope:
Press the Utility button and select LAN Set from the bottom menu. Set the desired connection type as LAN
under Type and select Set to open the right-hand settings menu. Then, in the right menu, make the same
settings as those made in the PC software. In the right menu, set the IP and Port Settings. Gateway and
Subnet Mask settings must also be adjusted to the network. Finally, select Set to apply the settings, so that
a message "Reset to update the config" appears. After resetting the oscilloscope, the settings have been
applied and you should be able to connect to the software.