Tus neeg siv phau ntawv

- 84 -
Change the network settings in the oscilloscope:
Press the Utility button and select LAN Set from the bottom menu. Set the desired connection type as
LAN under Type and select Set to open the right-hand settings menu. Then, in the right menu, make the
same settings as those made in the PC software. In the right menu, set the IP and Port Settings. Finally,
select Set to apply the settings so that a message "Reset to update the config" appears. After resetting
the oscilloscope, the settings have been accepted and you should be able to establish a connection to the
software.