User's Manual

X350 and X550 User Manual
Page 19
4. At the installer’s "Welcome" screen, click on the "Next" button.
5. At the software End User License Agreement and Terms of Use screens, read
the agreements and if you agree, click on the "I agree" checkbox, and then click
on the "Next" button.
6. When prompted, choose the default screen resolution for all the vSpace stations.
You can change this setting after you install vSpace.
7. From the "Select Destination Location" screen, you can choose to install vSpace
in the default location, or you can navigate to a different location and install
vSpace there. When you are finished, click on the "Next" button.
8. When asked if you want to add new users to the system, if you click on the "Yes"
button, the installation program will launch a screen to administer user accounts
on the host PC. If you click the "No" button, the installation process will continue
without bringing up the user administration screen.
If you choose to add or set up new User Accounts later, you can do so by going to Start-
>Control Panel->User Accounts. You can also search on “To add a new user to the
computer” in the Windows Help and Support Center for more information.
Note: It is strongly recommended that all users have their own user accounts to enable
control of their own settings. If you click on the “Yes” button, a Windows utility screen
(see the screen shots below for reference) will be displayed. When you are finished
adding users, close the Windows utility and you will be brought back to finish the vSpace
installation process.
Windows Server 2008 R2 and MultiPoint Server user account management screen