User's Manual

2424

The "System Settings" tree item shows the following settings for the terminal services software.

Double-clicking on the name of the setting allows you to adjust it, unless it is read-only, which is

specified below.

• Maximum number of stations (incl. Host): the maximum number of sessions the terminal

services software is configured to support. This number includes the host PC. This setting is

read-only.

• Current number of additional stations: the number of additional stations. This setting is read-

only.

• This machine: the name of the host PC. This setting is read-only.

• This user: the currently logged-in user’s username. This setting is read-only.

• System uptime: how long the system has been up. This setting is read-only.

• Start stations at boot?: whether or not the stations start when the host PC boots. You can set

this either on or off.

• Allow Shutdown/Reboot from stations: whether or not the stations are given the option to

shutdown or reboot the host PC. You can set this either on or off.

• X300 card video mode settings: The video mode settings for the X300 stations. You can set

this to either 800x600 or 1024x768.

• Allow only the last logged in user the shutdown of the system: whether or not it is required

that there is one and only one user logged on for the system to be shut down or rebooted. You

can set this either on or off.

• Delay until shutdown (seconds): the default amount of time after a shutdown command is

issued until the shutdown occurs. You can set the number of seconds.

• Disable Send Broadcast Message: whether or not the administrator has disabled broadcast

messages. You can set this either on or off.

• Support WTSAPI32 Interface: whether or not the terminal services software has turned on

support for the WTSAPI32 application interface. At times, this setting is required for certain

applications to behave properly. You can set this either on or off.