Datasheet

Overview

The Numo family of System-on-Chips (SoCs) are single chip devices that enable

OEMs to design high performance, low cost, thin clients and other devices. Numo 3

leverages multiple generations of NComputing Numo technology that is deployed

in millions of seats today. By adding support for Citrix HDX, Numo 3 delivers an

unmatched level of performance, capability and cost to further propel desktop

virtualization into enterprises worldwide.

The Numo 3 device is based on an ARM Cortex A9 Dual-Core processor and includes accelerators for

TCP/IP packet processing and cryptographic encryption – ensuring maximum network security with

minimal network impact. A powerful Numo codec is also integrated that ooads the processor from

CPU intensive video processing functions for HDX client-side rendering and is capable of decoding in-

coming H.263, H.264, MPEG2/MPEG4, JPEG, VC1 and Sorenson Spark streams of up to 1080P resolution.

These advanced graphics features enable support for the wide range of multimedia content

demanded by today’s end-users – while optimizing the use of host and network resources.

Numo™ 3 SoC system level block diagram

Standard peripheral ports include two USB 2.0 ports (for mouse, keyboard and other USB peripherals),

one of which can be interfaced to an external USB hub if additional ports are required. A USB OTG

host port is included for factory programming. The included Ethernet MAC has an interface to an

external GMII/MMI 10/100 or Gigabit PHY. Additional ports include stereo audio in/out (via interface to

external audio ADC), 8x GPIO pins, 2x Serial UART ports, 2x I2S interfaces, 4x I2C interfaces, a PCI-e (x1)

expansion bus, SATA 2 controller, and memory card interface for external SD/MMC cards. This variety

of ports enables a wide range of conguration possibilities to serve the special needs of practically any

thin client application.

Project brief:

Numo™ 3

32-bits

8-bits

NOR/NAND

FLASH

PCIe x1

SATA 2

SD/MMC

Cartão

Host USB OTG

USB 2.0 x2

SoC

DDR 3/2

RAM

VGA ou

HDMI/DVI

Áudio ADC

10/100/1000

Ethernet PHY

PAGE 1
Project brief: Numo™ 3 Overview The Numo family of System-on-Chips (SoCs) are single chip devices that enable OEMs to design high performance, low cost, thin clients and other devices. Numo 3 leverages multiple generations of NComputing Numo technology that is deployed in millions of seats today. By adding support for Citrix HDX, Numo 3 delivers an unmatched level of performance, capability and cost to further propel desktop virtualization into enterprises worldwide.
PAGE 2
Project brief: Numo™ 3 The device boots from an internal ROM and interfaces to up to 2GB of NAND Flash for typical configurations – a parallel NOR and serial Flash interface is also included. Up to 1GB of DDR3 1066 memory can be attached. The video output port supports an external VGA DAC or Digital HDMI/DVI interface, with up to 1920x1080 resolution at 60Hz covering current and future users’ video demands.