User Manual

ManualsBrandsNCE Corporation ManualsHobbyDCC Twin Starter Set with Power Supply

You're now ready to operate this locomotive!! Turn the knob of Throttle B slowly to the

right. The locomotive will start up and run forward. Turn the knob to the left past center

and watch the locomotive run in reverse!

Normal Operation

q Place the first locomotive back on the track and now you can operate locomotive 1 with

the Throttle A knob and locomotive 2 with the Throttle B knob. It doesn't matter that they

are on the same track, DCC allows you to do this. Just make sure you don't have any

“Adams Family” meet-ups along the way.

q Now what about those numbers above the push

buttons? They are “Function” buttons. With a locomotive

on the track, you can operate the lights by pressing the

LIGHT button. If you have a sound equipped locomotive,

you can ring the bell with button 1 or blow the horn or

whistle with button 2. Button 2 is a momentary push

button and will turn off when you release the button. The

other buttons will turn on with the first button push and off

with the next push.

q You can also HOLD DOWN the SHIFT key and press

1 but it will be Function 5. See the smaller 5 under the push button? Pretty cool, huh? You

can operate Functions 5, 6, 7, and 8 this way for a total of 9 Functions.

We're sure that you'll want to expand your railroad with more track, track switches or

“turnouts” and bridges and buildings.

A note about Kato Unitrack -

When using Kato Unitrack turnouts, they should be set to Non-Power Routing. See your

Kato turnout instructions for directions on this setting.

Technical Section

All locomotives programmed on Throttle A will be set to address 3.

All locomotives programmed on Throttle B will be set to address 4.

The DCC Twin is designed for two train operation on small layouts. It can be expanded to

several trains with the addition of NCE add-on throttles. Up to two additional add-on

throttles can be used with the Twin.

ProCab™ - 5240010

Using a ProCab with the DCC Twin converts the Twin to a full featured DCC system

including walk-around control, recalls and up to 29 functions. The ProCab provides the

most user-friendly access to all NCE system features.

Uncomplicated menus on the easy to read LCD display guide you through the most

advanced operations.

Cab 06 - 5240029

This throttle features a 4 digit LED display, support for 29 functions, up to 6 recalls and

can now control individual accessories as well as macros.

Throttle

REV FWD

1 2 3

LIGHT

SHIFT

5 6 7

8 PROG A

POWER

Figure 6