User's Guide

INSTALLING A ROLL OF PAPER
• Depress the printer
door release button
(see arrow) to
disengage the paper
door from the
terminal.
• Tilt the paper door
towards the rear of the terminal.
• Remove and discard the empty paper roll.
• Verify that the roller is intact and securely attached
to the paper door.
• Install the paper roll
(thermally coated side
exposed when viewed
from top) into the
compartment. The
thermally sensitive
side will create black
marks when it is
scratched.
• Tilt the paper door towards
the front of the terminal until
resistance is felt.
• Press down on both corners
of the paper door until it
clicks into position.
The
510H terminal is now ready for use.
INSTALLING A SIM CARD
The SIM card is located within the terminal.
• Power off the
terminal by pressing
the
key until
the display shuts
off.
• Carefully remove
the SIM card cover
which is located on
the bottom front of
the terminal.
• Install the SIM card
with the notch
facing out. See the
picture for the
correct orientation
of the card within
the slot.
FCC/IC COMPLIANCE
FCC ID: COL-NOIRE510H
IC: 2279B-NOIRE510H
This device complies with Part 15 of FCC Rules and
Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
The equipment fulfills the applicable FCC requirements
with respect to RF exposure to electromagnetic fields,
when used for the purpose and in the way it is intended
and described.
WARNING: Changes or modifications to the equipment
that are not expressly approved by the responsible party
for compliance could void the user’s authority to operate
the equipment.
SAFETY INSTRUCTIONS
Electrical power supply network
Provide an AC receptacle that meets the following
recommendations:
• Connector is installed near the equipment and is
easily accessible