User's Manual

NBS Payment Solutions 7/8 User Manual
Path of the cables
Plug and unplug the strain relief :
It could be more easier to put in place the strain relief by
unplugging the connector
proceed according to the figures below
Removing the cable:
N°1
To take of the cable, press
the flap N°1 and pull the
cable N°2.
N°2
Installing the cable:
Note : Take care to have sufficient available length of cable
in order to be able to remove the terminal from its base and
so, to be able to unplug the connector
The serial cable can go under the base to reach the opening.
Maybe by the way mentioned as 3, or right in front of the
connectors mentioned as 1 and 2.
Make a 18 mm diameter hole in the base in order to have a
path for a squared angle connector (14mm diameter in case
of base thickness lower than 14 mm.
Ethernet Cable (Option) Preparing the back cable cover
The Ethernet cable is optional.
The path is through the hole(2).
The opening in the table must be
14mm diameter
.
The back cover may be opened
as mentioned as 4 in order to
have a path for Ethernet cable.
(option)