User's Manual

WWW.NBSTECH.COM
14
USING THE BASE (MODEL NBS 502XB)
Once installed, the base is designed to remain on constantly
and connected to the telephone network.
→ The telephone line should not be shared.
The portable may be placed back in its base after each trans-
action.
It must be placed on its base in the following cases:
• When the telephone network is using (1) authorization re-
quest, (2) remote collection, (3) downloading
• When check processing, if the base is connected to a
check reader.
BATTERY AUTONOMY
When removed from its socket, the portable can perform up to
200 transactions at 20°C, provided completely charged batter-
ies are used.
STOPPING THE PORTABLE
When removed from its socket, after it has been used and if its
battery is empty, the portable automatically shuts off. The
screen is turned off.
To forced the portable to stop, press the "Point" and "Yellow"
keys simultaneously for one second.
In order to restart the Portable, press key on the keyboard.
PRECAUTIONS WHEN USING HEAT-SENSITIZED PAPER
To prevent the ticket from deteriorating in the event of improper
storage, avoid the following:
• Storage in areas that are hot and humid (close to a heater/
cooling unit, degree of humidity greater than 85%)
• Long-term exposure to sunlight or ultraviolet rays
• Contact with organic solvents (solvent-based adhesives)
• Direct contact with material containing softening
(plasticizing) agents (envelopes or clear plastic folders
made of PVC)
NBS5500 INSTALLATION & OPERATION MANUAL
15
• Direct contact with whiteprint paper
• Direct contact with water
• Rubbing or pressing the paper too forcefully
OPENING/CLOSING THE BATTERY
COVER FLAP
The battery cover flap is located under the portable.
Caution: Switch off the machine before opening the cover.
OPENING
1. Turn the PORTABLE over on
the table with the bottom
side facing up (figure oppo-
site).
2. Unclip the cover flap by
pushing on the clips with
your nails in the direction of
Arrow 1 as shown opposite.
3. Lift the cover flap on the clips
side (Arrow 2), disengage
the two rear limiting tabs
from underneath the terminal
housing, and remove the
cover flap.
CLOSING
To close up the device, carry out the above operations in the
reverse order.
1. Engage the two rear limiting tabs of the flap cover under
the terminal housing;
2. Fold the cover downwards to clip it on. If a SAM stops the
cover flap from closing, check the direction of its insertion.
3. Make sure the clips are totally engaged under the housing
by pushing them manually.