User's Manual

WWW.NBSTECH.COM
16
DE-INSTALLING THE SAM1 AND SAM2
MODULES
Caution: Turn off the terminal
before opening the cover.
• Open the battery compart-
ment cover flap (See §
"Battery cover flap"). Note
the location mark of the
SAM1 and SAM2 engraved
in the lower housing.
• When introducing a SAM in
its slot, be sure to put the cut
corner as indicated on the
figure opposite.
• Close the flap cover.
Removing
Handy tip: Use a piece of adhesive tape to grip the SAM to
make withdrawal easier.
OPENING/CLOSING THE CAM2 COVER
FLAP (SECONDARY READER)
CAM2 cover flap is located under the portable.
Caution: Switch off the machine before opening the cover.
OPENING
1. Turn the PORTABLE over on the table with the bottom side
facing up (as shown).
2. Unclip the cover flap by pushing both clips simultaneously
with your nails in the direction shown (See Arrows 1).
3. Lift the cover flap on the clips side (Arrows 2) and remove
the cover flap.
NBS5500 INSTALLATION & OPERATION MANUAL
13
KEYPAD KEY ASSIGNMENTS
DAILY USE
CARD INSERTION AND READING DIRECTION
Reading the magnetic stripe
(on a swipe or chip card):
1. Position the card as
follows:
• front side towards the right
(magnetic stripe is on op-
posite side).
• upper edge of card
(defined with respect to
text reading direction) set
at reader lead-in.
2. Run the card by hand through the reader. (Arrow 1).
Inserting a chip card : Chip facing up (Arrow 2)
F1, F2, F3, and F4 are
interactive keys for
screen operator dialog.
Function Key
Cancel Key (Red)
Correct Key (Yellow)
Validation Key (Green)
Up/Down
Navigation
Control
Start or Paper
Feed Key