User's Manual

WWW.NBSTECH.COM
12
Operating conditions
Class II
Electrical network : 100-240VAC; 50-60 Hz
Consumption : 150 mA
Power supply block : 2 pole socket 2,5 A
Ambient temperature : +5°C to +45°C
Maximum relative humidity : 85% at +40°C
Serie link : level RS 232 / V28
Mini-USB A serie link
Mini-USB B serie link
Storage conditions
Storage temperature : -20°C to +55°C
Maximum relative humidity : 85% at +55°C
Paper References No.
To benefit from the full product warranty, you must use thermal
paper authorized by NBS. Paper roll diameter: 40 mm.
UNPACKING THE NBS5500
Carefully preserve the packaging of the NBS5500. It must be
re-used whenever the terminal is shipped.
Packaging contains:
• PORTABLE itself, equipped with its battery pack (not con-
nected) and paper roll
• Base receiving the PORTABLE
• Detachable power supply unit. (The power supply unit de-
livered with your terminal is specially designed for it. Do not
use any other power supply.) The use of a power supply
having apparently similar voltage/current characteristics
may, in spite of this, damage your terminal
• Telephone cable
• Installation manual
NBS5500 INSTALLATION & OPERATION MANUAL
17
CLOSING
To close up the device, carry out the
previous operation in the reverse
order.
1. Engage the front of the flap
cover under the terminal hous-
ing.
2. Fold the cover backwards to clip
it on.
3. Make sure the clips are totally
engaged under the housing by
pushing them manually.
DE-INSTALLING THE SAM3 AND SAM4
(OR SIM) MODULES
The SAM3 and SAM4 (or SIM) modules are installed under the
CAM2 cover flap.
Location 4 may be used by a SAM or a SIM.
Caution: Switch off the machine before opening the cover.
1. Open the CAM2 cover flap
(See "Opening/Closing the
CAM2 Cover Flap"). Note the
location mark of SAM3 and
SAM4 engraved in the lower
housing.
2. When introducing a SAM in
its slot, be sure to put the cut
corner as indicated in the fig-
ure opposite. The position of
the cut corner is also en-
graved on the lower housing.
3. Close the flap cover.