User Manual

Page 7
LED RADIO ON
Checking theLED at thereceiver PNN-R-16 andPNN-R-CAN:
The Green LED flashes:
Service plug: Information about this programming plug see customized
specifications in the annex.
RADIO PRESENT.
If the LED fails to come on:
1. Check that the transmitter is on.
2. Check the power supply of the receiver.
3. (Optional) Irregular flashing of the LED:
Check or change the current radio channel.
The rating plates state the serial number, the unit model, the HF part model and the
frequency.
Always state the serial number in all your queries.
Please observe the particular postal approval regulations of the concerning country.
Your NBB radio remote control is largely maintenance-free. Nevertheless, please bear in
mindthe followingpoints:
EMERGENCY STOP switch must be easy to move.
Remove any leftover building materials!
During electro-welding work on the unit to be controlled, disconnect the receiver from
thecurrentsupply! Otherwise there is a risk of damage to the receiver's electronic
system!
Check wear and tear parts like dust shield tops regular!
We grant a function warranty for 6 months after the sale date for all NBB radio remote
controls (transmitter, receiver, charger). The warranty covers working time and material
used. Shipping costs shall be charged to the customer. The warranty shall not cover:
wear and tear parts, relays and batteries. The function warranty shall be invalidated in the
case of damage, accident damage, negligence, incorrect use, non-compliance with
operating conditions, non-compliance with operating, testing and maintenance
instructions, and repairs or unit modifications not authorised by NBB. NBB shall not be
liable for indirect damage and reserves the right to decide on repair or replacement.
Do not attempt to continue working with a defective NBB radio remote control. Even
initially minor defects might be the start of a moreextensive defect.
Do not try to repair the NBB radio remote control yourself. If there is any fault please
contact your dealer or our company.
%
%
%
%
NOTE:
CAUTION:
This equipment has been tested and found to comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacture
could void the user's authority to operate the equipment.
SERVICE PLUG
8. RATING PLATES
9. LICENSING
10. MAINTENANCE
11. WARRANTY
12. IN CASE OF DEFECTS
13. FCC