User Manual

Page 1
%
%
%
%
Portable transmitter with two replaceable 7,2 volt NiCd batteries, rubber cover, hand
strap and belt clip.
Receiver with NBB adapter plate for fastening purposes (PNN-BUS-3), receiver with 4
fixing angles (PNN-BUS-5), with 1 mounting bracket (PNN-R-10) or with integrated
mounting holes (PNN-R-6, -16, -CAN and PNN-Compact).
Multi-pin connecting cable for the receiver according to your specifications.
Automatic battery charger with charging adapter (rapid charging in three hours).
For explanatory notes on obtaining an operating permit please refer to registration docu-
ments enclosed in the appendix of this operating instruction. Observe all applicable work-
safety and accident prevention regulations carefully. Only fully trained, authorized per-
sonnel may use the NBB radio control equipment. Components, etc. built into the NBB
equipment for safety purposes must beregularly inspected.
Failure to observe these recommendations will put both you yourself and others at risk.
Under these circumstances, NBB rescinds the guarantee and any other form of liability.
This radio control unit is designed exclusively for the control of construction machines
and industrial plants. Only under these conditions are the safety systems (STOP, resp.
EMERGENCY STOP, zero setting) fully effective. No other form of use is permitted. Any
non-observance of thisconditionwill relieve NBB of allliability.
The actual delivery specification is as detailed on the confirmation of order or
the delivery note accompanying the goods!
Even if you are accustomed to working with radio control systems, read these
operating instructions carefully before using this equipment. Only this docu-
ment contains the latest information relating to your NBB radio control system.
If the NBB radio control unit develops a fault, it must be shut down immediately.
The transmitter should be switched off with the STOP key, resp. EMERGENCY
STOP switch. The connecting cable must be disconnected at the receiver from
the connecting socket (terminal) of the unit to be controlled . The repair of the
equipment must not be carried out other than by NBB or an NBB authorized tech-
nician.
1. STANDARD SPECIFICATION
2. SAFETY PRECAUTIONS