User's Manual

8
NBB Controls +
Components
GmbH
Transmitter PocketEvo
®
Operation of the system
> Switching the transmitter on and off
CDC-key (Customer Data Collection)
– The transmitter can only be started with the CDC-key inserted.
– If the CDC-key is not present, the display changesbetween “no” and “tA”.
– CDC-key contains customer-specific parameters.
Design with emergency stop
– Unlock the emergency stop pushbutton by turning clockwise to switch on the transmitter.
– The transmitter vibrates shortly.
– In operation two red dots flash alternately in the display.
– Switch off the transmitter by pressing the emergency stop pushbutton once.
After pressing the emergency stop pushbutton, the transmitter sends stop telegrams for 2 seconds
to switch off the system. This shut-off time is displayed on the LED display by the external segments
rotating clockwise.
To ensure faultless free operation, please observe the following rules:
The system to be controlled – provided the transmitter is ready for operation – can only be switched on
if no command is activated. To start the system to be controlled and to activate the functions press the
“On/Horn” button, which also triggers a horn signal. Due to work specifications, the same button is
used for triggering repeated horn signals.
> Frequency change
To change the frequency, press and hold the left side button “On/Horn”. Press now the right side
button “frequency change”. If the receiver locks on a new frequency, a horn signal is triggered and
the system is ready for operation. Please observe the country-specific regulations.
Operation: Two red dots flash
alternately.
1. On/Horn
2. Frequency change