User's Manual

ManualsBrandsNBB Controls + Components ManualsElectronicsPocketEvo

NBB Controls +

Components

GmbH

Transmitter PocketEvo

Transmission frequency range See nameplate

Data security Addressing each transmitter using a unique Binary bit code combination

Data repetition rate Approx. 15 ms/60 ms

LF-modulation GFSK

Baud rate 9.600 Baud (Bit/sec.)

Range Up to 100 m (depending on environment)

Operating voltage

2,4 V – 2 x AA 1.2 V NiMH batteries

3,0 V – 2 x 1,5 V batteries

Current consumption < 100 mA bei 3 V

RF output < 750 μW

Protection class IP 65

Operating ambient temperature – 20 to + 70 °C

Weight (without battery)

PocketEvo

minor / PocketEvo

minor-LCD: approx. 600 g

PocketEvo

media / PocketEvo

media-LCD: approx. 660 g

PocketEvo

magna / PocketEvo

magna-LCD: approx. 730 g

Masse (L x B x H)

PocketEvo

minor / PocketEvo

minor-LCD: 257 x 93 x 60 mm

PocketEvo

media / PocketEvo

media-LCD: 285 x 93 x 60 mm

PocketEvo

magna / PocketEvo

magna-LCD: 321 x 93 x 60 mm

> Surface Mounted Push buttons teach mode activation with pushbutton and display

To activate teach mode, the transmitter must be switched off.

1. Press and hold the “Frequency switching” key.

2. Switch the transmitter on.

3. The letters “tt” appear in the monochrome after 2 seconds.

4. Release the “Frequency switching” key.

5. Push the button all the way down as quickly as possible. If the corresponding push button number

appears in the display, the push button can be released again. Repeat step 5 for all other SMP push

buttons. It is not necessary to reactivate the teachmode.

6. Teachmode ends automatically when all SMP push buttons are activated. The transmitter vibrates

shortly.

7. Attention! The transmitter is now in working mode!

Push buttons to enter and store min and max values for valves could differ from the description above.

In this case a separate supplemental information sheet will be attached to the operating instructions.

Technical data

If “tt” does not appear in the display, please switch off the transmitter

and start teach mode activation from the beginning!