User Manual

5. OPERATING THE UNIT
+
1
2
3
4
ON/HORN
RADIO ON/
EMERGENCY STOP
FREQUENCY
CHANGE
FREQUENCY CHANGE
Safety equipment in the NBB-radio remote control:
In the transmitter
In the receiver:
If the NBB radio remote control is not used for a long period, it is urgently recommended -
if you use rechargeable batteries - that they should be charged now and again (about
every 4 weeks). This prevents deep discharges of the batteries and prolongs their useful
life. If you shut down the NBB radio remote control for a long period, we recommend you
take the batteries out of the transmitter.
Frequency change:
Channel number:
Teach In:
, this comprises mainly:
STOP, resp. EMERGENCY STOP with automatic disconnection of the power supply.
Automatic zero positioning.
Two diversity units for evaluation of the STOP, resp. EMERGENCY STOP signal.
Automatic zero setting when switching back on after radio interruption.
Locking of the radio commands at relay level in the event of a defective STOP, resp.
EMERGENCY STOP circuit.
To ensure fault-free operation, please follow precisely the following rules for operation:
The unit to be controlled can only be switched on - it is assumed that the transmitter is
ready to operate - when no command unit is actuated. The command necessary to do so
is triggered by the key "ON/HORN". This triggers a horn signal in the unit to be controlled.
After switch-on of the facility to be controlled, this key is used for repeated emission of the
horn signal in accordance with working regulations.
To change the frequency, keep the "ON/HORN" key presseddown. Then operate the
"FREQUENCY CHANGE" key. If the receiver locks into the new frequency, a horn signal
is given (if present) and the unit to be controlledis ready for operation.
Please observe the particular postal approval regulations of the concerned country.
When changing the frequency the channel number lights up in the
display (HyPro). During operation the choosen channel can be shown by pressingthe
“FREQUENCY CHANGE” key.
(See example on the left)
w
as well
as the outer button on the left side above
%
%
%
%
%
"ON/HORN" once. The transmitter will go hen exchanging one of the joysticks a
"TEACH IN" has to be done: Push both outer buttons on the right side of the keypad
and keep them pushed for seven (7)
seconds. The display will say "JOY TEACH" and the command to fully stroke joysticks will
appear. Move each joysticks all the way down and then all the way up. To exit the teach
mode center all joysticks and push the button back to the normal operational mode.
Page 4
+