User's Manual

COMPACT-M

LED RADIO ON

SERVICE PLUG

To maintain operational safety, a regular function check of the NBB radio remote control is

necessary. In single-shift day-to-day operation, we recommend performing this check at

least once a week. Checking is possible using the display lights provided on the receiver.

To do so, the transmitter must be set to the ready-to-operate state.

%First connect just the receiver - the transmitter remains switched off.

%Ensure in particular that there is nobody in the danger area. ACCIDENT RISK!

%STOP, resp.

Activate the transmitter by unlocking the EMERGENCY STOP switch, resp.

pressing the key "START/ON/HORN".

Now check the commands (always start with the lowest stage) and check for

correct function of the unit to be controlled.

EMERGENCY STOP check. Press the EMERGENCY STOP switch at

the transmitter until the switch engages, resp. press the STOP key. Then observe

if the unit to be controlled is switched off (time to switch off according to

the application).

Checking the LED display at the receiver: Compact-M, Compact-M2 and

Compact-V.

Receiver connect to power, without communication with transmitter :

1. LED constant ON (green)

2. LED flashing irregular (orange) --> receiver searching transmitter

Connect to transmitter:

1. LED flashing regular (green)

2- LED flashing regular (orange) --> Comunication ok

1. LED flashing irregular (green)

2. LED flashing irregular (orange) --> Interference on RF signal --> (change frequency)

1. LED flashing regular in 1 sec. interval - (red) --> Emergency relay fault.

2. LED flashing regular (orange)

Receiver Compact-M with charger: (optional)

3. LED flashing regular (yellow) --> battery charging

3. LED constant ON (yellow) --> battery full charged

Service plug: For NBB service only.

6. FUNCTION CHECK

www. nbb.de

COMPACT-V

3.820.1195

LEDS

SERVICE PLUG

LEDS

3 2