User's Manual

%Portable transmitter.
%Receiver with integrated mounting holes.
%Optional: Multi-pin connecting cable for the receiver according to your
specifications.
The actual delivery specification is as detailed on the confirmation of order or
the delivery note accompanying the goods!
Even if you are accustomed to working with radio control systems, read these
operating instructions carefully before using this equipment. Only this docu-
ment contains the latest information relating to your NBB radio control system.
For explanatory notes on obtaining an operating permit please refer to registration docu-
ments enclosed in the appendix of this operating instruction. Observe all applicable work-
safety and accident prevention regulations carefully. Only fully trained, authorized per-
sonnel may use the NBB radio control equipment. Components, etc. built into the NBB
equipment for safety purposes must be regularly inspected.
If the NBB radio control unit determines a fault, it must be shut down immediate-
ly. The transmitter should be switched off with the STOP key, resp. EMERGENCY
STOP switch. The connecting cable must be disconnected at the receiver from
the connecting socket (terminal) of the unit to be controlled . The repair of the
equipment must not be carried out other than by NBB or an NBB authorized tech-
nician.
Failure to observe these recommendations will put both you yourself and others at risk.
Under these circumstances, NBB rescinds the guarantee and any other form of liability.
This radio control unit is designed exclusively for the control of construction machines
and industrial plants. Only under these conditions are the safety systems (STOP, resp.
EMERGENCY STOP, zero setting) fully effective. No other form of use is permitted. Any
non-observance of this condition will relieve NBB of all liability.
1. STANDARD SPECIFICATION
2. SAFETY PRECAUTIONS
3. TRANSMITTER
Start up 2,4V: To prepare the unit for use, screw of the battery compartment on the back
of the transmitter and remove the cover. Insert 2 charged AA batteries (NiMH or Alkaline)
into the battery compartment. Close the cover and tighten the screw plug.
Rechargeable batteries (NiMH or NiCd) must be fully charged before first use!
Never attempt to charge standard non rechargeable 1,5V AA batteries!
Start up 7,2V: To make the unit ready for use, insert the battery into the battery
Compartment. To remove the battery, press in the pin and push out the battery.
Press in the pin
and push out the battery