User's Manual

%
%
%
Portable transmitter.
Receiver with integrated mounting holes.
Multi-pinconnecting cable for the receiver according to your specifications.
For explanatory notes on obtaining an operating permit please refer to registration docu-
ments enclosed in the appendix of this operating instruction. Observe all applicable work-
safety and accident prevention regulations carefully. Only fully trained, authorized per-
sonnel may use the NBB radio control equipment. Components, etc. built into the NBB
equipment for safety purposes must be regularly inspected.
Failure to observe these recommendations will put both you yourself and others at risk.
Under these circumstances, NBB rescinds the guarantee and any other form of liability.
This radio control unit is designed exclusively for the control of construction machines
and industrial plants. Only under these conditions are the safety systems (STOP and zero
setting) fully effective. No other form of use is permitted. Any non-observance of this con-
dition willrelieveNBB of all liability.
The actual delivery specification is as detailed on the confirmation of order or the delivery
note accompanyingthe goods!
Even if you are accustomed to working with radio control systems, read these operating
instructions carefully before using this equipment. Only this document contains the latest
information relating to your NBB radio control system.
If the NBB radio control unit develops a fault, it must be shut down immediately. The trans-
mitter should be switched off with the STOP key. The connecting cable must be discon-
nected at the receiver from the connecting socket (terminal) of the unit to be controlled .
The repair of the equipment must not be carried out other than by NBB or an NBB authori-
zed technician.
Page 1
3. TRANSMITTER
1. STANDARD SPECIFICATION
2. SAFETY PRECAUTIONS
Switching on: To make the unit ready for use, unscrew the screw plug of the battery com-
partment on the back of the transmitter and remove the cover. Insert 2 charged AA Mi-
gnon batteries 1,2V NiMH (or batteries 1,5V - not rechargeable) into the battery compart-
ment, closethecover and tighten thescrew plug again.
Rechargeable batteries(NiMHorNiCd) must befullychargedbefore firstuse
Never attempt to charge standard non rechargeable AA batteries
!
1,5V !
The functions of the receiver are released with the “ON/HORN” key.
The receiver has to be switched off with the "STOP" key when work is finished.
AreddotflashesonthePlanardisplayduringoperation.
The transmitter switches off automatically, if the keys are not pres-
sed within a specified time. The red dot goes out.
Optional: Transmitter for continuous operation possible.
Energy saving function:
*The duration of this stand-by can be specified when ordering.
Operation:
The red dot flashes.
8
Slowly flashing:
Batteries are to low, to
operate the transmitter.
L