1
IMPORTANT NOTES INTRODUCTION Thank you for buying our product. Please read through these operating instructions, so you will know how to operate your equipment properly. After you finished reading the instructions manual, put it away in a safe place for future reference. WARNING To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid electrical shock, do not open the cabinet; refer servicing to qualified personnel only.
FEATURES AND CONTROLS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. HANDLE CD COMPARTMENT CD DOOR OPEN/CLOSE STANDBY ON/OFF BUTTON POWER INDICATOR FM STEREO INDICATOR DISPLAY VOLUME CONTROL TUNING CONTROL BASS BOOST BUTTON CD PLAY/PAUSE/USB BUTTON CD STOP BUTTON CD SKIP/SEARCH BACKWARD BUTTON CD SKIP/SEARCH FORWARD BUTTON FUNCTION SWITCH BAND SWITCH 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. CD FOLD.+/+10 BUTTON PROG./P-MODE BUTTON CD FOLD.
AM BAND Select AM mode by band selector switch. Turn the TUNING control to select the desired station. For AM reception, the set is controlled by a built-in ferrite aerial which is directional. Therefore, the set should be positioned for the best signal strength. LOADING THE BATTERIES INTO THE REMOTE HANDSET Open the battery compartment cover. Insert two “AAA” batteries (not included) as indicated inside the battery compartment. Close the cover. KEY FUNCTIONS: 1. 2. 3. 4. 5. 6. 7. 8.
TAPE RECORDING A. Install a cassette tape. B. Set the FUNCTION SWITCH to “RADIO” position. After selecting the desired band and tune the TUNING KNOB to desired broadcast station. Then push down RECORD BUTTON and PLAY BUTTON simultaneously. C. After recording the desired broadcast, depress the STOP/EJECT BUTTON lightly, and then set FUNCTION SWITCH to “TAPE” position in order to listen to the recorded broadcast. D.
USING THE CD/MP3 LOADING A DISC 1. 2. 3. 4. Set the FUNCTION switch to CD/MP3/USB/AUX position. Open the CD door. Place an audio CD into the tray with the label side facing up. Close the CD door. The total number of tracks will appear on the display after several seconds. 5. To remove the CD, press OPEN to open CD compartment lid, grasp the CD by its edges, and carefully take it out. Note: To ensure good system performance; wait until the disc tray completely reads the disc before proceeding.
To Erase the Memory (Program) To clear the program, you have two options: 1. Press the STOP button when the disc is stopped, or 2. Open the CD compartment lid, program will be erased. REPEAT To Repeat a Single Track 1. Press the PROG./P-MODE button once in play mode, “ REPEAT ” will flash on the display. The current track will be played repeatedly until the STOP button is pressed 2. Press the PROG./P-MODE button once more to cancel. To repeat all the Tracks 1. Press PROG.
AUX IN OPERATION This unit has provided special AUX IN jack, through this jack other audio sources can be connected to this unit and be amplified. 1. Set the FUNCTION switch to CD/MP3/USB/AUX position. 2. Connect the audio cable into the AUX IN jack and the other end connect to the AUDIO OUT jack of the external audio source. The unit will change to AUX mode automatically. 3. Adjust the volume of the main unit to your desired level. Press PLAY of the external audio source to start playback.
