Installation Guide

14
Chevrolet Tahoe 2012-2014
Testing and Settings
• Test HDMI input if you are connecting any HDMI video source.
• Press and hold supplied push button for 3-5 seconds. The interface will activate on the screen.
• Single press of the push button will cycle through the available video inputs.
• Press the push button until HDMI input is highlighted and you will enter the HDMI mode.
• Video signal from your HDMI source will appear on the screen. If no video source is connected or
the connected source is not correctly working, you will see this message.
• Test AV inputs by selecting them in the menu of the interface or if you are installing any
aftermarket cameras.
• To test aftermarket front camera, put the car in reverse then into drive. Front camera should display
on the screen.
• To test aftermarket left and right cameras, use left and right turn signals. Left and right cameras
should display depending on the turn signal activated.
After everything is tested and working, reassemble the vehicle.
(The remainder of this page is intentionally left blank)
STEP 4