User's Manual

Page 3 of 13
2 Introduction
This purpose of this guide is to provide sufficient information to allow a HDR100/CIR Series
radar to be physically installed, powered up and configured to correctly communicate over a
network. This guide assumes that a suitably trained person has already performed a site
survey and a suitable mounting location identified. The radar, together with the Navtech Radar
software Witness, form the basis of your system unless you have chosen an OEM option, in
which case you have the hardware only. Service and Maintenance procedures are covered in
a separate manual.
2.1 Support
Navtech Radar Ltd offer comprehensive support services both pre and post radar
commissioning to ensure you get the best performance and support for your radar installation.
Navtech Radar Ltd have a dedicated Customer Services Support Centre that can offer 1st and
2nd line technical support for both hardware and software queries. The centre is staffed by a
highly skilled technical team who can advise and offer support with any technical questions
both pre and post commissioning. In the event a fault cannot be diagnosed remotely, or a
repair is required, the team can arrange for your radar to be returned to base for further
diagnostic tests or repair.
Navtech Radar Ltd also offer a number of support plan options during the lifetime of your radar,
offering peace of mind for your installation.
For further information on the support plan options or any technical questions please contact
the Customer Services Support Centre on [phone], or email at
[e-mail]
2.2 FCC Certification and Compliance
These radar systems may only operate as vehicular radars, or as fixed or mobile radars in
airport air operations areas, including but not limited to FOD detection radars and aircraft-
mounted radars for ground use only.