Operation Manual

14
Turning on and off
For normal operation, turn off your Navman by sliding the power switch to the OFF position. Your Navman
enters a suspended state. To use it again, slide the power switch to the ON position. Your Navman will be back
to where you left off.
F300 F400
Shutdown and hardware reset
Occasionally, you may need to perform a hardware reset if your Navman stops responding; or appears to be
“frozen” or “locked-up.”
You can perform a hardware reset by shutting down your Navman and then turning it back on. To shut down
your Navman, slide the power switch to the RESET position. To turn on your Navman after shutting it down,
slide the power switch to the ON position.
NOTE: Switching to the Reset position turns the battery off. It is recommended you move the switch to this position if you are
planning to store your Navman for any length of time.
How do I monitor the battery status?
Your Navman has an internal battery that when fully charged, should provide power for up to 3 hours.
You can monitor battery power status on the Power screen.
Note: The battery may not be fully charged when you use your Navman for the first time.
To access the Power screen, tap .
How do I charge the battery?
The Battery Status bar displays External Power while the battery is charging; when the battery is fully charged,
the Battery Status bar will display at 100%.
 To charge your Navman in a vehicle, plug the in-vehicle charger to the bottom of your Navman and
the other end into the vehicle power socket, as shown in the” How do I install my Navman?” section.
 To charge your Navman using your computer, see later section for details.
 To charge your Navman using a mains power socket, plug the mains power charger cable to the
bottom of your Navman and the mains power charger pack into the mains power socket.
Note: The mains power charger is not included with all models and may be purchased separately.