Operation Manual

34
Diesel fuel flow sensor kit Installation and Operation Manual
NAVMAN
Installing the tachometer pickup
Warning: The pickup is fitted near a
rotating part of the engine. Make sure you
do not touch any rotating part. Mount the
pickup firmly so it will not break off and
fall into the engine. When working near the
engine, do not wear loose loose clothing;
tie back long hair.
1 Clean any grease or dirt off the area
where you are going to stick the reflective
tape. Wipe the area with a cloth or tissue,
then use the alcohol wipe provided to
degrease the surface.
2 Peel the self-adhesive backing from the
tape and stick it in position on the rotating
part.
3 Fit a mounting block for the tachometer.
Remember the engine will move and
rock on its flexible mounts. Make sure the
mounting bracket is strong so that it will
not vibrate when the motor runs or in a
heavy pounding sea.
3 Continue with installation (see section
7-7).