Operation Manual

24
Diesel fuel flow sensor kit Installation and Operation Manual
NAVMAN
If you do use tape, then to prevent pieces of
tape from breaking off:
Make sure you wind the tape on to the
male thread so that the first couple of
threads remain uncovered; do not cover
all of the threads.
Be careful when snapping off the tape
that threads of tape do not fall back over
the end of the fitting.
If removing fittings from previous installs make
sure the male threads are cleaned of any
remnants of the thread sealer used. If re-using
any fittings with female threads be particularly
careful about removing remnants of thread seal
- it is hard to see on an internal thread.