Operation Manual

User’s manual SEAT Portable System
Operating the navigation system - 23 -
Showing and hiding the Compass symbol
You can activate and deactivate the Compass symbol so that it is
shown or hidden.
► In the NAVIGATION window tap on Options > Settings > Navigation.
► Scroll with the (To the Left) and (To the Right) buttons
until you see the Display Compass setting.
The currently valid setting value is highlighted (red).
► Tap on the (Toggle) button to alternate between the setting
values.
► Tap on OK.
Energy
The Energy symbol can indicate the following states of the integrated
battery:
The device is mounted in the vehicle and is being supplied with power
from the vehicle. The battery is fully charged.
The device is mounted in the vehicle and is being supplied with power
from the vehicle. The battery is in the process of being charged.
The device is in the vehicle and is being supplied with power from the
vehicle. The battery cannot be charged because its temperature is too
high or too low.
The device is being supplied by its internal battery. The battery charge
is sufficient.
The device is being supplied by its internal battery. The battery charge
is low.
Traffic Information (TMC)
The navigation system has an integrated TMC receiver which supplies
up-to-date traffic information. Using this information the navigation
system can change your route dynamically, for example in order to
avoid a traffic jam.
Note: This function is only available if TMC traffic messages are being
transmitted in the country in which you are travelling. This is not the
case in all countries.
The TMC symbol can display the following TMC reception status:
Tuning (in red): The TMC receiver is operational but cannot find a
transmitter that is sending TCM signals. There are no active traffic
messages.