Operation Manual

User’s manual SEAT Portable System
- 14 - Before you begin
Supplying power to the navigation device
The navigation device is supplied with power via the cradle. At the
same time the device's battery is charged so that it can also be used
outside the vehicle, e.g. for pedestrian navigation.
The LED on the bottom of the navigation device is active only when the
navigation device is being charged via a charger or is connected by a
USB cable to a computer. In this case its colour has the following
meaning:
► Orange: The device is in the process of being charged.
► Green: The battery is fully charged.
The LED on the bottom of the navigation device lights up orange during
charging.
As soon as the battery is fully charged, the LED lights up green.
Note: It takes approx. 3 hours to charge the device when the battery is
flat.
A fully charged battery enables up to 3 hours of use depending on the
device configuration.
Traffic Information (TMC)
The navigation device has an integrated TMC receiver. As soon as it is
mounted, the device can receive traffic message updates. If required, it
can change your route dynamically, e.g. in order to avoid a traffic jam.
2.4.3 Memory card
A memory card is not required to operate the navigation system
because all the data needed for navigation are stored in the internal
memory of the device.
Note: If you purchase additional navigation maps, they must be saved
in the internal memory of the navigation device. Navigation data on the
memory card are not used. The slot for memory cards is intended only
for media which you can play back with the media player or the picture
viewer.
When you connect the navigation system to your computer using a USB
cable, the internal memory is detected as the 'NAVIGON' drive. The slot
for the memory card is detected as the 'NAVIGON SD' drive.
Data backups, software updates and navigation map updates can be
carried out quickly and conveniently with the NAVIGON Fresh software,
which you can download free of charge from the website
www.navigon.com/fresh.
Caution! Do not remove the memory card from the device while the
data saved on it are in the process of being used, e.g. for playing back
music or viewing pictures. Data may be lost as the result.