User's Manual

Federal Communications Commission
Requirements
Warning: CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE WITH THE
FCC’ RULES ( THE FCC’ GRANTEE’ ) COULD VOID
THE USER’S AUER’S AUTHORITY TO OPERATE
THE EQUIPMENT.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital devices,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses an can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be de-
termined by tuning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
1. Reorient or relocate the recieving antenna.
2. Increase the seperation between the
equipment and reciever.
3. Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
4. Consult the dealer or an experienced radio/TV
technical for help.
THIS DEVICE COMPLIES WITH PARTS 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE,
AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED. INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
CE Marking
This equipment complies with the requirements for
CE marking when used in a residential, commercial,
vehicular or light industrial environment.