User's Manual

User’s manual NAVIGON 70/71
Note: The Voice Command function is not available in every language.
For languages in which this function is available, the Voice Command
button is shown in the N
AVIGATION window. For languages which are
not supported, the Voice Command button is replaced by the Show
Map button.
Many functions of your navigation device can be called up conveniently
by voice command.
5.1 Activating the voice commands function
The voice commands function is automatically active in many windows.
This applies in particular to windows in which you are expected to
provide an answer, for example when there is a new traffic message
concerning your route.
Proximity sensor active:
If the proximity sensor is active, you can also activate the voice
command function in the N
AVIGATION window, in the map and in the
H
ANDSFREE MODULE window as follows:
Touch the frame of the navigation device.
As soon as you take your hand away again you will hear a single
prompt tone and you can utter your command.
Proximity sensor inactive:
On the map in Standard or Navigation mode, the Voice Command
function will be activated as soon as the button bar is shown:
Tap on any point on the map.
You will hear a single acknowledgement tone and you can utter
your command.
For more information on the proximity sensor refer to "Proximity
sensor", page 57.
5.2
- 26 -
Use Voice Command
When the functions in a window can be called up by voice command,
this is indicated in the top left corner of the window by the symbol
(Voice command active).
A single signal tone and the symbol (Speak) indicate that the
navigation system is waiting for your voice command.
Say a command.
The positive acknowledgement tone sounds (two high-pitch tones)
and the function is executed.
Voice Command