User's Manual

3
User’s manual NAVIGON 70/71
Switching on the navigation device
Press the (On/Off) key and keep it pressed until the device
switches on.
The N
AVIGATION window opens.
Note: The screen lights up briefly in white, indicating that you have
started the device.
When you switch on the navigation system for the first time, you will be
asked to make the following settings:
your preferred language for using for the software
the unit of length for distances
the time format
the date format
Note: When you start the navigation application for the first time, the
D
EMO MODE settings window opens.
Demo mode is intended only for demonstrating the product when no
GPS reception is possible.
When demo mode is active, navigation is not possible! Demo mode
is designed solely to simulate navigation to the centre of the
indicated destination.
Make sure that the Start in Demo Mode setting is at No. If
necessary tap on the (Toggle) button in order to change
the setting from Yes to No.
Tap on OK.
Note: How to deactivate demo mode is explained in "Troubleshooting"
in section "I have accidentally activated demo mode" on page 123.
Note: If you have not used the navigation device for a long time, the
battery may be flat.
When you connect the navigation device to the supplied car charger
cable, it can be switched on immediately even if the battery is flat. If you
use a different charger cable or have connected your device to a PC, it
may need charging for a few minutes before it can be switched on.
Chargers and other accessories are available in the NAVIGON online
shop at www.navigon.com
or in specialist stores.
Switching on the navigation device - 17 -