Operation Manual

User’s manual NAVIGON 14xx | 24xx
Working with the map - 43 -
Simulation: Simulates a navigation on the route indicated. This simulation can
be performed without GPS reception. On multi-leg routes, only the first
leg is simulated.
Skip Route Point
: Tap this button to omit the next route point. This button is
active only when at least 2 route points still lie ahead of you. (Refer to
"Multi-leg routes or tracks" on page 35)
Start Recording
, Stop Recording: Starts or ends the recording of a track. (Refer
to "Tracks" on page 60)
Traffic
(only NAVIGON 24xx): Opens the TRAFFIC INFORMATION window in
which pending reports are listed. (Refer to "TMC (Traffic Information)"
on page 67)
Turn
-b
y-Turn List
: Shows detailed directions for the route, including all points at
which you must turn. (Refer to "Turn-by-Turn List" on page 65)
7 Working with the map
7.1 Selecting the navigation map
Each country has its own navigation map. Seamless navigation over
several maps on one continent is possible however if a continuous
route can be calculated with the maps saved on the device.
Even if maps of countries in other continents are available on the
navigation device, the NAVIGON 14xx | 24xx can only ever work with
the maps of a single continent.
Tap in the N
AVIGATION window on Options > Settings > Map Display in
order to see which maps are currently in use. Here you can also select
a different continent if the navigation device contains any maps of
countries on other continents.
7.2 Map in Standard mode
The map is always in Standard mode when you are not navigating,
have not calculated a route and are not searching for a destination on
the map.
Under the following circumstances the map switches automatically to
Standard mode:
► You begin a trip while the NAVIGATION window is open. The map is
switched over a short time later.
► You reach the destination of a navigation in Vehicle mode.
To open the map: